PH32-08A
Front-mounted hydraulic sweeper for loader, backhoe and other equipment

Front-mounted hydraulic sweeper for loader, backhoe and other equipment (PH32-08A)
Front-mounted hydraulic sweeper for loader, backhoe and other equipment (PH32-08A)
Front-mounted hydraulic sweeper for loader, backhoe and other equipment (PH32-08A)
  • Front-mounted hydraulic sweeper for loader, backhoe and other equipment (PH32-08A)
  • Front-mounted hydraulic sweeper for loader, backhoe and other equipment (PH32-08A)
  • Front-mounted hydraulic sweeper for loader, backhoe and other equipment (PH32-08A)

Features

  • Own hydraulic unit
  • 16 gage hood covering 180░ of the brush
  • The brush is driven by single hydraulic motor coupled directly to the core by a splined shaft
  • 32"ě broom, polypropylene, wire or polypropylene/wire
  • Brush width: 8'
  • Swing arm system allows the brush to follow ground variations
  • Pressure of the brush to the ground is adjustable by two springs
  • Brush is supported by two flange bearings
  • Anchor and lifting rings
  • 30░ right / left hydraulic angle
  • 20hp Honda engine
  • Electric starter and 12 volts battery, 500 amperes and 20 amperes alternator
  • 30 gallons hydraulic tank and oil cooler
  • 15 gpm pump to supply the brush
  • 2 gpm pump for hydraulic angle
  • Oil level gage
  • Line diffuser, 10 microns filter
  • Remote control to start engine, sweep and angle
  • Hour meter
  • Epoxy primer and urethane paint
  • Weight:

Options

  • Adjustable dirt deflector
  • Female quick attach for loader
  • Quick attach female
  • Quick attach male
  • Additional remote control
  • Quick connect for the remote control
  • Turbo-filter