RTH32-09-02 / RTH32-10-02
Standard Features
Brush Drive
- Requires, 24 GPM at 2000 PSI (190 LPM at 138 bar) for a recommended brush speed of 150 RPM.
- Brush speed is controlled by the equipment engine speed
- Powered dual hydraulic orbital motors mounted to the core of the brush
- Third valve is required to operate the brush, a fourth valve is required to operate the hydraulic angle change and a fifth valve is required to open or close the upper
- Hydraulic hoses that supply the third valve of the equipment must be 3/4" (19 mm) inside diameter.
Brush
- Choice of poly, wire or poly / wire bristles
Hydraulic Angle Change
- 2" diameter hydraulic cylinder
- Hydraulic hoses with quick coupler to hook up to the fourth valve (if available)
Open / close upper
- 2 hydraulics cylinder 1 1/2" diameter to opening the upper 115° (without remove the upper)
- Hydraulic hoses with quick coupler to hook up to the fourth valve
- .8 cubing yard
Mechanical Components
- Pressure to the ground is controlled by two springs
- Shock absorbers to reduce brush hopping
- The brush is mounted on two 1 3/4" (45 mm) diameter flange bearing
- Stopper to protect the shock absorber
- Anchor rings for handling and transportation
- Storage stands
- Level gauge for the floating feature
- Heavy duty motor safety guard(s)
Frame
- 90% of the parts are laser cut for a good finish and design
- Cross member are heavy duty rectangular tubing
- 16 gauge steel hood covering 180° of the brush
- All main parts of the frame, including the hood, are bolted together for a quick replacement
- 1 1/2" (38 mm) diameter pivot axle for the angle device
Finish
- All parts are sandblasted individually.
- One coat of epoxy primer and one polyurethane top coat
On Mounted Sprinkler System
- The purpose of the sprinkler system is to reduce airborne dust when sweeping
- 150 gallons water tank with support to be mounted directly on the sweeper for an easy storage
- 12 volt electric water pump
- Electric switch to start and stop the water pump
- Electric wire with quick plug for an easy storage of the broom
- 5 spray nozzles mounted into the hood for a direct watering of the brush
Diverter Valve for Hydraulic Angle Change or open / close upper
- Needed to be able to supply the hydraulic angle cylinder or open / close the upper if only a third valve on equipment
- Electric switch to activate the valve with electric wire with quick plug for storage of the broom
Options
Travel Spring Kit
- The purpose of the travel springs is to absorb shocks cause by irregularities of the road when the broom is lift-up and the equipment is travelling at a high speed. They basically act as a ride control
Casters
- Prevent the brush from wearing out in a cone-shape way
- 18.5" diameter rear caster wheel
Gutter broom
- The gutter broom with the manual diverter valve and flow control clean near to the side walk