PH32-08A

Features

Front mounted broom for loader, backhoe or loco tractor
Own hydraulic unit
16 gage hood covering 180° of the brush
The brush is driven by single hydraulic motor coupled directly to the core by a splined shaft
32"Ø broom, polypropylene, wire or polypropylene/wire
Brush width: 8'
Swing arm system allows the brush to follow ground variations
Pressure of the brush to the ground is adjustable by two springs
Brush is supported by two flange bearings
Anchor and lifting rings
30° right / left hydraulic angle
20 Hp Honda engine
Electric starter and 12 volts battery, 500 amperes and 20 amperes alternator
30 gallons hydraulic tank and oil cooler
15 gpm pump to supply the brush
2 gpm pump for hydraulic angle
Oil level gage
Line diffuser, 10 microns filter
Remote control to start engine, sweep and angle
Hour meter
Epoxy primer and urethane paint
Weight: