PH32-07CH / PH32-08CH
Features
- Sweepers for loader and backhoe
- Driven from equipment hydraulic system
- The brush is driven by single hydraulic motor coupled directly to the core by a splined shaft
- 32"Ø broom, polypropylene, wire or polypropylene/wire
- Brush width: 7', 8'
- 16 gage hood covering 180° of the brush
- Swing arm system allows the brush to follow ground variations
- Pressure of the brush to the ground is adjustable by two springs
- Brush is supported by two flange bearings
- Two 18.5-6.5-8 front caster wheels
- Anchor and lifting rings
- Hydraulic angle change 30° right and left
- 2 Jack stands for storage
- Epoxy primer and urethane paint
- 10' hydraulic hoses ¾"Ø with spool motor
- Weight 7': 495 kg or 1120 lbs
- Weight 8': 548 kg or 1208 lbs
Necessary Features on Equipment
- Requires 16 gpm at 2000 PSI with a maximum of 25 gpm at 3000 PSI
- ¾"Ø hydraulic hoses from pump to the sweeper
- Third valve to power the brush
- Fourth valve for the hydraulic angle
- Male quick coupler
Options
- 150 gallons water tank, pump, plumbing, sprayers and mounting brackets on the sweeper
- 200 gallons water tank, pump, plumbing, sprayers and mounting brackets at the rear of the equipment
- Adjustable dust deflector to reduce airborne dust
- Large travel spring to absorb shocks during travel
- Female quick coupler
- Diverter valve for hydraulic angle
- Flow control