RPL24-07
Features
- Sweepers for forklift
- Driven from equipment hydraulic system
- The brush is driven by single hydraulic motor coupled directly to the core by a splined shaft
- 24"Ø broom, polypropylene, wire or polypropylene/wire
- Brush width: 7'
- 16 gage hood covering 180° of the brush
- Swing arm system allows the brush to follow ground variations
- Brush is supported by two flange bearings
- Two 16.5-6.5-8 front caster wheels and 1 16.5-6.5-8 rear caster wheels
- Anchor and lifting rings
- Manual angle change 30° right and left
- Hopper capacity: 0.5 cubic yards capacity
- Retractable hopper when sweeping at 30° angle
- Epoxy primer and urethane paint
- 10' hydraulic hoses ¾"Ø with spool motor
- Weight: 770 kg or 1700 lbs
Necessary Features on Equipment
- Requires 12 gpm at 2000 PSI with a maximum of 25 gpm at 3000 PSI
- ¾"Ø hydraulic hoses from pump to the sweeper
- One double action oil exit (side shift) to power the brush.
- One double action oil exit to open and close the hopper.
- Minimum width between forks: 24"
- Maximum width between forks: 43"
- Maximum fork lift width: 8"
Options
- 50 gallons water tank, pump, plumbing, sprayers and mounting brackets on sweeper
- Diverter valve to open the hopper if only one oil exit on equipment