RLH32-08
Features
- Brooms for forklift
- Supply by equipment hydraulic system
- The brush is driven by single hydraulic motor coupled directly to the core by a splined shaft
- 32"Ø broom, polypropylene, wire or polypropylene/wire
- Brush width: 8'
- 14 gage hood covering 180° of the brush
- Swing arm system allows the brush to follow ground variations
- Brush is supported by two flange bearings
- Two 16.5-6.5-8 front caster wheels and one 18.5-8.5-8 rear caster wheel
- Anchor and lifting rings
- Hopper capacity: 0.5 cubic yards
- Hopper is opened and closed by two 1 1/2" diameter hydraulic cylinder
- Epoxy primer and urethane paint
- 10' hydraulic hoses ¾"Ø with spool motor
- Weight: 865 kg or 1900 lbs
Necessary Features on Equipment
- Requires 16 gpm at 2000 PSI with a maximum of 25 gpm at 3000 PSI
- ¾"Ø hydraulic hoses from pump to the broom
- One auxiliary oil exit to supply the brush.
- One auxiliary oil exit to supply the hopper cylinders.
- Minimum width between forks: 35 1/2"
- Maximum width between forks: 56 3/4"
- Maximum forklift width: 10 3/4"
Options
- 100 gallons water tank, pump, plumbing, sprayers and mounting brackets on broom
- Gutter broom, manual selector and flow control
- Diverter valve to open the hopper if only one auxiliary oil exit on the equipment